1   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   z

1. houses of ill-repute--the plan is to construct a number of cad models utilizing other model parts and extruded surfaces.

2002.07.11 11:40
Re: Parametric Design
I have used parametric tools, and I know how to use them passively and actively.
For the record, I'm utilizing to term 'parametric tools' to describe those computer aided functions / commands that require usually a set of parameters to be input for the command to follow through. For example, a rotate and extrude command needs:
1. a predrawn line formation that is to be rotated and extruded--the profile of a vase, for example.
2. two points to designate the axis around which the line formation is to be rotated, usually parallel to the profile.
3. various variables must be decided upon, e.g., how many facets should the extrusion manifest as it rotates around the axis? should the extrusion do a full 360 degrees or less?
The interesting, though not taught, part of all this is that just by slightly (or greatly) changing the angle of the axis of rotation, an entirely unpredictable extruded form will result. It is this unpredictability of what is essentially an infinite amount of possibilities that computer aided design really engenders. Only by being arbitrary with the parameters does one begin to see what all possibilities really means, or at least look like.
This is a somewhat difficult to describe with just a few words. A full demonstration with many diagrams and steps is really required. Nonetheless, look at the images within wqc/dossiers/surfaces. These images are the results of where arbitrary portions of 3-d spline lines are rotated (mostly 45 degrees) and extruded around an arbitrarily chosen axis. It is only after having done many such experiments (and being arbitrary allows for many, many quickly executed experiments) that I have begun to use this command arbitrarily but with some predictability. Essentially, I now know what some of the parameters are likely to engender.
If you think about it, the process I followed is really neither purely active or passive. I was not a slave to the programming, nor to the notion of 'finding' the right parameters for the right result. I also didn't bring any preconceived ideas to the program (such as drawing the axis of rotation always parallel to the profile). I 'played' it.

2003.01.14 11:20
Re: FW: essay on gehry
We discussed 3D CAD surface 'play' as virtual sculpture.

2006.02.19 14:42
Iconography, or the problem of representation
Bad Hair Day Architecture

Yeah, reality bites.

Venus Fly Trap Architecture

Gosh, reality really bites.

These are just two examples of how Quondam can help your architecture in today's chaotic world. Do you have ultra-original architecture that no one can easily understand? Then don't worry! Quondam can look at your project and within minutes provide you with the right visual formula to present your great design to the world.

2008.04.27 12:00
the state of drawing in education
...there is abundant room for messiness and experimentation and discovery within CAD.



Quondam © 2016.09.05